On and Off Remote and Receiver with White Wall Plate F2236 RCKIT4001
On and Off Remote and Receiver with White Wall Plate F2236 RCKIT4001
This remote control system was developed to provide safe, reliable, and user-friendly remote control system for gas heating appliances.
The system can be operated manually from the transmitter. The system operates on one of 255 settable security codes on the
transmitter and receiver.
The transmitter has ON and OFF functions that are activated by pressing either
button on the face of the transmitter. When a button on the transmitter is
pressed, a signal light on the transmitter illuminates briefly to verify that a signal
has been sent. Upon initial use, there may be a delay of three seconds before
the remote receiver will respond to the transmitter. This is part of the system’s
design. If the signal light does not illuminate, check the position of the
transmitter’s battery.
The transmitter has (2) code switches located on the back that will need to be set
when installation is complete. Note: Code setting section
The transmitter operates on (1) 3V Button Cell (Included) that powers the RF
signal. Before using the transmitter the 3-volt battery must be installed into the
battery compartments.
Remove the battery holder from the bottom of the transmitter insert the 3-volt
button cell battery in the battery holder with the plus (+) side up. Note the drawing
at the left.
It is recommended that a CR2032 lithium battery always be used for longer
battery life and maximum operational performance.
This remote control system was developed to provide safe, reliable, and user-friendly remote control system for gas heating appliances.
The system can be operated manually from the transmitter. The system operates on one of 255 settable security codes on the
transmitter and receiver.
The transmitter has ON and OFF functions that are activated by pressing either
button on the face of the transmitter. When a button on the transmitter is
pressed, a signal light on the transmitter illuminates briefly to verify that a signal
has been sent. Upon initial use, there may be a delay of three seconds before
the remote receiver will respond to the transmitter. This is part of the system’s
design. If the signal light does not illuminate, check the position of the
transmitter’s battery.
The transmitter has (2) code switches located on the back that will need to be set
when installation is complete. Note: Code setting section
The transmitter operates on (1) 3V Button Cell (Included) that powers the RF
signal. Before using the transmitter the 3-volt battery must be installed into the
battery compartments.
Remove the battery holder from the bottom of the transmitter insert the 3-volt
button cell battery in the battery holder with the plus (+) side up. Note the drawing
at the left.
It is recommended that a CR2032 lithium battery always be used for longer
battery life and maximum operational performance.
- Regular price
-
$134.96 - Regular price
-
- Sale price
-
$134.96
Shipping calculated at checkout.
Couldn't load pickup availability
